initial

infrared-read/infrared-read.ino

@@ -0,0 +1,51 @@
+/*
+  ESP8266 BlinkWithoutDelay by Simon Peter
+  Blink the blue LED on the ESP-01 module
+  Based on the Arduino Blink without Delay example
+  This example code is in the public domain
+
+  The blue LED on the ESP-01 module is connected to GPIO1
+  (which is also the TXD pin; so we cannot use Serial.print() at the same time)
+
+  Note that this sketch uses LED_BUILTIN to find the pin with the internal LED
+*/
+#define IR_RX_PIN 14
+#define IR_TX_PIN 12
+#define SERIAL_BPS 115200
+
+#define POWER_BUTTON 0xFFEA15
+#define  EDIT_BUTTON 0xFF7887
+#define  EXIT_BUTTON 0xFF38C7
+#define   ONE_BUTTON 0xFF08F7
+#define   TWO_BUTTON 0xFF8877
+#define THREE_BUTTON 0xFF48B7
+#define  FOUR_BUTTON 0xFFC837
+#define  FIVE_BUTTON 0xFF28D7
+#define   SIX_BUTTON 0xFFA857
+#define SEVEN_BUTTON 0xFFE817
+#define EIGHT_BUTTON 0xFF18E7
+#define  NINE_BUTTON 0xFF9867
+#define  ZERO_BUTTON 0xFFB847
+
+#include <IRremote.h>
+
+IRrecv irrecv(IR_RX_PIN);
+decode_results results;
+
+int ledState = LOW;
+volatile byte IRInputState;
+
+void setup() {
+    IrReceiver.begin(IR_RX_PIN, ENABLE_LED_FEEDBACK); // Start the receiver
+    pinMode(LED_BUILTIN, OUTPUT);
+    Serial.begin(SERIAL_BPS);
+    Serial.print("herro booted\n");
+}
+
+void loop() {
+  if (IrReceiver.decode()) {
+      Serial.println(IrReceiver.decodedIRData.decodedRawData, HEX);
+      IrReceiver.printIRResultShort(&Serial); // optional use new print version
+      IrReceiver.resume(); // Enable receiving of the next value
+  }
+}